Computer case parts Raspberry Pi

Enclosure base,carbon fibre Raspberry Pi Model A/B Enclosures
Ensure your Raspberry Pi computer is properly protected in this specially designed, high impact polystyrene (HIPS) enclosure. As well as safely housing your Raspberry Pi, this case simply clips together without the need for screws or glue. No modifications are required either as all cut-outs have already been pre-cut into the case. The enclosure is available in a variety of colours with the top and base sold separately, allowing you to mix and match any combination of colours you like.
- Designed for Raspberry Pi Model A and B computer boards
- Two-piece construction with clip-in grooves
- All cut-outs are pre-cut into the case
- Mix and match with a variety of coloured lids and bases
- Gloss finish, high impact polystyrene (HIPS)
- The 'carbon fibre' finished enclosure is made from acrylic capped ABS
- Supplied with rubber feet
- Place your enclosure base onto a steady surface
- Tilting your Raspberry Pi at a 45° angle, align the audio and RCA video ports with the machined holes in the base and push until the PCB clips into the PCB groove
- Push the opposite side of the PCB down so that it clips into the second PCB groove in the base
- Placing the top cover at a 45° angle clip over the USB and LAN connectors, then clip the opposite end of the top cover onto the base
- Peel of the protective film on both the top and base of the enclosure
- Push the supplied feet into place if required